Publicidad
Idiomas disponibles
Idiomas disponibles
* : Energy Label standard program (EN
61121:2012) All values in the table are
determined according to EN 61121:2012
standard. Consumption values may vary from
the values in the chart depending on laundry
type, wringing speed, ambient conditions and
voltage levels.
5.5 Auxiliary functions
Buzzer / time
Drying machine makes an audible warning
when the program is completed. If you don't
want the machine to make an audible warning,
press the "Buzzer / Time" button. When you
press the Buzzer/Time button, a light will
illuminate and no audible warning will be made
when the program ends.
C
NOTE
•
You can select this function before or
after the program starts.
Buzzer/Time button is used to adjust program
duration while the Rack/Time programs are
selected.
Drying Level
Drying Level button is used for adjusting to
desired dryness level. Program duration may
change depending on the selection.
C
NOTE
•
You can activate this function only prior
to start of program.
End time
You can delay the end time of the program up
to 24 hours with End time function.
1.
Open the loading door and place the
laundry.
2.
Select the drying program.
3.
Press the End Time selection button and
set the delay time you wish. End Time
LED will illuminate. (When pressed and
hold the button, End Time proceeds non-
stop).
4.
Press the Start / Stand-by button. End
Time countdown starts. ":" Separator in
the middle of displayed delay time flashes.
14
C
NOTE
•
You can add or remove laundry within
end time. Displayed time is the sum of
normal drying time and end time. End
Time LED will turn off at the end of
countdown, drying starts and drying LED
will illuminate.
Changing the end time
If you want to change the duration during the
countdown:
Cancel the program by turning the On/Off/
Program selection knob. Select the program
you want and repeat the End Time selection
process.
Cancelling the end time function
If you want to cancel the end time countdown
and start the program immediately:
Cancel the program by turning the On/Off/
Program selection knob. Select the program
you want and press the Start/Stand-by button.
5.6 Warning indicators
C
NOTE
•
Warning indicators may vary depending
on the model of your dryer.
Filter cleaning
When the program is completed, the warning
indicator for filter cleaning turns on.
Water tank
When the program is completed, the warning
indicator to empty the water tank turns on.
If the water tank fills up while the program
continues, the warning indicator starts flashing
and the machine goes into stand-by. In this
case, empty the water tank and start the
program by pressing the Start / Stand-by
button. Warning indicator turns off and program
resumes.
Filter drawer /Heat exchanger cleaning
When the programme is finished, the cleaning
symbol of the heat exchanger or filter drawer
may light up.
Dryer / User Manual
Publicidad
