Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
8
- Do not use the appliance to treat areas on which you have recently
applied topical counterirritants (creams or ointments containing e.g.
menthol), as this can cause a mild inflammatory reaction.
Caution
- If the wall socket used to power the appliance has poor connections,
the plug of the appliance becomes hot. Make sure you plug the
appliance into a properly connected wall socket.
- Do not subject the appliance to heavy shocks.
- Always unplug the appliance after use and in case of a power failure.
- Place the appliance on a stable, level surface. Make sure there is at least
15cm free space around it for HP3621, 25cm free space for HP3631
and 35 cm free space for HP3643 to prevent overheating.
- Do not use the appliance at room temperatures lower than
10°C or higher than 35°C.
- Make sure the vents in the back of the appliance remain open during use.
- Do not cover the appliance with, for example, a cloth or a piece of
clothing when it is switched on.
- The appliance is equipped with an automatic protection against
overheating. If the appliance is insufficiently cooled (e.g. because the
cooling vents are covered), the appliance switches off automatically.
Unplug the appliance and remove the cause of overheating. Once the
appliance has cooled down, it can be switched on again. To do so, plug
the appliance in again and press the on/off switch.
- Let the appliance cool down for approx. 15 minutes before you clean
or store it.
- If you have just been swimming or have just taken a shower, make sure
you dry your skin properly before you use this appliance.
- Never use the appliance when the filter is damaged, broken or missing.
- Fully unwind the mains cord.
- Make sure the distance with your body and the appliance is large
enough to prevent accidental contact with the hot filter.
- Do not let the mains cord come in contact with the filer when the
filter is hot.
- Do not attempt to replace the lamp if the lamps stops working.
Contact the Philips Consumer Care Centre for information.
- HP3643: To make sure all parts are properly assembled, check if the
spring-loaded lock buttons are visible in the holes.
- HP3643: To avoid getting your fingers stuck when you adjust the height,
hold the lamp housing by one of the handgrips or by the hinge as long
as the height adjustment rings are unlocked.
Publicidad
