Emerio SEW-122275.3 Manual De Instrucciones página 9

Winding the bobbin
The bobbin winder bar is used to wind your own bobbins from the thread spools you purchase separately.
Normally, the bar is hidden in the hand wheel. When you need to wind a bobbin:
1. Press and hold on the bar.
2. Turn the bar counterclockwise; the bar will pop out.
3. Attach the empty bobbin onto the bar firmly and wind the thread on it clockwise for 4 to 5 circles.
4. Press the on/off switch to turn on the appliance. The thread will be winded automatically. Hold the thread
lightly and guide it gently through your finger. See reference picture as above. Do not wind the thread over
the rim of the bobbin.
5. Press the on/off switch to turn off the appliance when finished. Cut the thread and take off the bobbin.
6. Press the bobbin winder bar into the hand wheel and turn it clockwise to hide it back.
Caution! Before winding the bobbin, please take out the bottom bobbin and remove the top thread completely.
Replacement of the side bobbin
1. Pull the bobbin spindle out from the bobbin holder.
2. Take off the bobbin and replace with a new one.
3. Push the spindle with the new bobbin back to the bobbin holder.
How to use the needle threader
1. Insert the needle threader into the hole of the needle from the right to left.
2. Insert the thread into the needle threader at the left side of the needle and then pull the needle threader
out to the right side.
Sewing sleeves
The appliance is designed to allow you to sew sleeves easier with the sleeves sewing slot. Follow the operating
steps to sew the sleeves.
Working lamp
If additional light is needed, press the light switch to turn the light on. Press the switch again to turn it off.
- 8 -