Functions Of The Electronic Plough Control - LEMKEN -EPS Instrucciones De Servicio

4 FUNCTIONS OF THE ELECTRONIC PLOUGH CONTROL

Each function will be carried out by pressing the corresponding function button:
Attaching and Detaching
=>
Before attaching and detaching the plough the function button (15)
must be pressed. The headstock and the drawbar turn to the ideal
attaching and detaching position = The drawbar is parallel to the
ground.
=> Pitch adjustment
Press function button (2), to set the plough on the „point".
=> Press function button (11), to set the plough on the „blade".
=> Working width per body
Press function button (3), to increase the working width per body.
=> Press function button (12), to decrease the working width per
body.
=> Front furrow width
Press function button (4), to increase the front furrow width.
Press function button (13), to decrease the front furrow width.
=>
The stated value show the adjustment value in % and not the cur-
rent front furrow width in cm.
Turning the plough frame
=>
Lift the plough completely and press function button (10). The
plough frame will be swung-in, turned and swung-out again.
Uncoupling the press
=>
After pressing the function button (1) the catching pin of the at-
tachment arm will be unlocked. After a few seconds the catching
pin moves back to the catching position.
13