Electromagnetic Fields (Emf); Boil-Dry Protection; Using The Appliance; Cleaning And Descaling - Philips Aluminium Collection HD4690/05 Manual De Instrucciones

Depending on the hardness of the water in your area, small spots may appear on the heating
,
element of your kettle when you use it. This phenomenon is the result of scale build-up on
the heating element and on the inside of the kettle over time. The harder the water, the
faster scale will build up. Scale can occur in different colours. Although scale is harmless, too
much scale can influence the performance of your kettle. Descale your kettle regularly by
following the instructions given in the chapter 'Descaling'.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

Boil-dry protection

This kettle is equipped with boil-dry protection. This device will automatically switch the kettle off if
it is accidentally switched on when there is no water or not enough water in it. The on/off switch
will stay in 'on' position, but the power-on light ring will go out. Set the on/off switch to 'off ' and let
the kettle cool down for 10 minutes. Then lift the kettle from its base to reset the boil-dry
protection. The kettle is now ready for use again.
Before first use
1 Remove stickers, if any, from the base or kettle.
 Place the base on a dry, stable and flat surface.
 You can adjust the length of the cord by turning the cord winder clockwise to make it
shorter or anticlockwise to make it longer (Fig. ).
Before using the kettle for the first time:
4 Rinse the kettle with water.
5 Fill the kettle with water up to the maximum level and let it boil once (see 'Using the
appliance').
6 Pour out the hot water and rinse the kettle once more.

using the appliance

1 Open the lid by pressing the lid release button (Fig. ).
 Fill the kettle with water (Fig. 4).
You can fill the kettle either through the spout or through the open lid.
 Close the lid.
Make sure that the lid is properly closed to prevent the kettle from boiling dry.
4 Place the kettle on its base.
5 Put the plug in the wall socket.
6 Set the on/off switch to 'on' (Fig. 5).
The power-on light ring goes on and the kettle starts heating up.
The kettle switches off automatically when the water has reached boiling point. You will hear
,
a bell and the light ring goes out.

cleaning and descaling

Always unplug the appliance before cleaning it.
Do not use any abrasive cleaning agents, scourers etc. to clean the kettle.

EnglisH