Connections - Yamaha ATS-1050 Manual De Instrucciones

Connections

Connect to a TV (or other peripheral device).
CAUTIONS
• Do not connect the power cable of the sound bar to the AC wall outlet before making
connections.
• Do not use excessive force when inserting the cable plug. Doing so may damage the
cable plug or terminal.
1
Connect the TV and sound bar with the optical
cable (supplied).
Remove the cap of the optical cable and check the
direction of the plug.
2
Connect the power cable of the sound bar to an
AC wall outlet.
3
Set the TV as follows.
• Set the TV volume to minimum.
• Disable the TV built-in speaker output (if available).
HINT
• If a setting to disable the speaker output is not available on your TV, you may disable it
by connecting headphones to the headphone jack on the TV. For details, refer to the
manuals of the TV.
• The TV and BD/DVD input jacks support the following audio signals.
− PCM (2 channel)
− Dolby Digital (up to 5.1 channel)
6
Sound bar (rear)
Power cable
To AC wall outlet
TV
Optical cable
TV
HDMI cable (etc.)
Playback device
(such as a BD player)
Set top box
BD/DVD ANALOG SUBWOOFER OUT
OPTICAL OUTPUT
HINT
In the following cases, connect the coaxial digital
audio output of the playback device to the BD/DVD
input of the sound bar with a coaxial digital cable
(commercially available), then select the BD/DVD
key on the remote control for the input source.
− The TV does not have an optical output.
− The TV does not output audio (or outputs low
volume audio) from the connected playback
device.
− The audio from the playback device connected to
the TV cannot be heard as surround sound.