Antec PERFORMANCE 1 Manual Del Usuario página 4

the thumbscrews on the tray retaining plate
(see Photo 1) and remove it.
4. Slide the motherboard tray towards the drive
cage and pull up to remove it. Place the tray
on a flat surface.
5. Line up your motherboard with the stand off
holes, and remember which holes are lined up. Not all
motherboards will match with all of the provided holes; this is normal, and
won't affect functionality.
6. Screw the brass standoffs into the threaded holes that line up with your
motherboard. Do not overtighten the standoffs. Some standoffs may be
pre-installed for your convenience.
7. Place your motherboard on the brass standoffs.
8. Attach your motherboard to the standoffs with the provided Phillips-head
screws. Your motherboard is now installed.
9. Replace the motherboard tray in the case and slide it into position.
10. Reinstall the motherboard tray retaining plate.
Connecting the Front Control Panel with Temperature Display
The P160W includes a front control panel that can rotate up to 45 degrees. It
contains Power and Reset buttons, two USB 2.0-compatible ports, one IEEE
1394 (FireWire, i.Link) port, Audio In/Out jacks and a temperature display. To
power the LED temperature display, connect a 4-pin power connector from the
power supply to the 4-pin connector that powers the front panel.
Connecting the Power Switch and LEDs
1. Connect the main power connector and 4-pin +12V connector from your
power supply to your motherboard.
2. The Reset switch (labeled RESET SW) connects to your motherboard at the
RST connector. Make sure you always attach the colored wire to Pin 1,
and the black wire to ground.
3. Connect the Power Switch (labeled POWER SW) to the PWR connector on
the motherboard.
4. Connect the Power LED (labeled POWER) and HDD LED connectors to the
appropriate headers on your motherboard.
5. Decorative Blue LED: The front panel includes three decorative
blue LEDs over each of the front air intake vents. Locate the Molex 4-pin
male connector from the bezel and connect it to a 4-pin connector from the
power supply. The LEDs will light when you power-up your system.
Connecting the USB Ports
You will find a single 10-pin connector on a cable attached to the front USB
ports. This is an Intel standard connector, which is keyed so that it can't be
accidentally, reversed when connected to a proper Intel standard motherboard.
Connect the 10-pin connector to the motherboard headers so that the blocked
pin fits over the missing header pin.
Note: Please check the motherboard manual for the USB header pin layout and
make sure it matches the attached table. If it does not match this Intel stan-
dard, please call Antec customer service at
(800) 22ANTEC (North America) or +31 (0) 10 462-2060 Europe) to buy a
3
Photo 1