Cleaning And Storage; Low Battery Indication - König Electronic HC-KS40 Manual De Uso

Tare (set zero) function
It is easy and convenient to build up & mix different ingredients together all in the same cup. After the first
ingredient is added and measured, you may add another ingredient after performing the tare function as
described below.
- Place the cup with first ingredient on a flat table.
- Press [0] button once. The reading will reset to zero and the "TARE" icon will remain in the display.
Now you can add your additional ingredient. Only the weight or volume of the last ingredient added is
measured.
NOTE: The tare function only measures correctly when the cup is placed on a flat surface.
Reversing the Tare function
Right after the tare function has been performed and the display is showing "0" with the "TARE" icon, you can
press [0] to show the original weight or volume again. The "TARE" icon will then disappear.
NOTE: The reverse tare function only operates when the cup is placed on a flat surface.
IMPORTANT NOTE:
It is easy and convenient to mix different ingredients in the cup. However, when mixing your ingredients,
you should avoid pressing down the bottom of the base where the sensitive weight scale components are
located. Excessive force applied to the base of the cup may permanently damage the scale inside and result
in inaccurate readings.
FAULT MESSAGE DISPLAY
UnSt: Unstable
T he scale is unstable and the unit will turn off automatically. Place the cup on a flat table and turn on
the unit again by pressing [0] once.
Err: Error
The scale is overloaded. The weight or volume in the cup exceeds the maximum display range (refer
"Specification" section).

CLEANING AND STORAGE

Cleaning:
• Only clean the inside of the cup with cold/warm water and a mild cleaning detergent, do not use hot water.
• Use damp cloth to clean the outside.
• Never immerse the cup in water or put it into a dish washing machine.

LOW BATTERY INDICATION

Low battery indication is available. Replace the batteries and follow the setup procedure in this instruction
manual.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused
due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for these
products.
3