Failure Display And Inspection - CORBERO CCIG321 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The touch controls are
unresponsive.
The touch controls are
difficult to operate.
The glass is being
scratched.
Some pans make crackling
or clicking noises.
The induction hob makes
a low humming noise
when used on
a high heat setting.
Fan noise coming from the
induction hob.
Pans do not become hot and
appears in the display.
The induction hob or a
cooking zone has turned
itself off unexpectedly, a
tone sounds and an error
code is displayed (typically
alternating with one or two
digits in the cooking timer
display).

8. Failure Display and Inspection

If an abnormality comes up, the hob will enter the protective state automatically and display
corresponding protective codes:
Error Code for Ceramic hob
Problem
E0 & repeated
beep sound
warning.
The controls are locked.
There may be a slight film of
water over the controls or you
may be using the tip of your
finger when touching the
controls.
Rough-edged cookware.
Unsuitable, abrasive scourer or
cleaning products being used.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
This is caused by the technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you've turned the
induction hob off.
The induction hob cannot detect
the pan because it is not suitable
for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Technical fault.
Possible causes
Overheating protection:
the hob is over heated.
Unlock the controls. See section
'How to use' for instructions.
Make sure the touch control area is dry
and use the ball of your finger when
touching the controls.
Use cookware with flat and smooth
bases. See 'Choosing the right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
This is normal, but the noise should
quieten down or disappear completely
when you decrease the heat setting.
This is normal and needs no action. Do
not switch the power to the induction
hob off at the wall while the fan is
running.
Use cookware suitable for induction
cooking. See section 'Choosing the right
cookware'.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note down the error letters and
numbers, switch the power to the
induction hob off at the wall, and
contact a qualified technician.
What to do
Stop cooking till the internal temperature back to
normal. Please contact after sales service to
check the hob if there is PCB failure.

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ccvg321Ccvg21d

Tabla de contenido