Installation; Before The Installation; Attaching The Seal - On-Top Installation - Electrolux LHR3233CK Manual De Instrucciones

3. INSTALLATION

WARNING!
Refer to Safety chapters.

3.1 Before the installation

Before you install the hob, write down the
information below from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
3.3 Connection cable
• The hob is supplied with a connection
cable.
3.5 Assembly
min.
500mm
• To replace the damaged mains cable, use
3.4 Attaching the seal - On-top
installation
1. Clean the worktop around the cut out
2. Attach the supplied 2x6mm seal stripe to
3. Add some millimetres to the length when
4. Join the two ends of the seal stripe
min.
50mm
the cable type: H05V2V2-F which
withstands a temperature of 90 °C or
higher. Speak to your local Service
Centre.
area.
the lower edge of the hob, along the
outer edge of the glass ceramic. Do not
stretch it. Make sure that the ends of the
seal stripe are located in the middle of
one side of the hob.
you cut the seal stripe.
together.
R 5mm
+1
490 mm
+1
270
min.
55mm
mm
ENGLISH 73