Problem And Solution - PURIFY F Serie Manual De Usuario

PROBLEM AND SOLUTION

PROBLEM
Can not turn on or key has no
response.
The air quality indicator of the
device, despite the bad smell of the
air, is green.
The air quality indicator is always
red.
Sound during operation
The smell of the supply vent is
unpleasant.
Not into sleep mode automatically
in the night.
The purifier has been running for a
long time but has had no significant
improvement in air quality.
The display shows F1 or F2.
Machine immediately goes to sleep
mode.
For updates on this manual or further FAQs, consult the website www.purify-air.it/faq
EN
SOLUTION
• Is the Power cord plugged in?
Plug in the power cord.
• Is the purifier covered?
Close the front cover.
• Is the machine placed vertically on the ground?
Place themachine on a flat surface.
• Is the machine in child-lock mode?
When "Child-lock" appears on the display, hold the
lock/reset button for 5 seconds to turn off the child-lock.
Is the purifier in a place that cannot easily absorb
the dirty air (dust)?
Move it somewhere else
Is the particulate sensor dirty?
Clean the particulate sensor.
Is there too much dust on the anion producer?
Clean the anion producer.
• Is the filter dirty?
Clean the filter.
• Has the filter been replaced in a long time?
Replace the filter.
Purifier in manual mode? Press "Auto" button on the control
panel, make sure enter the Auto mode.
• Was the plastic bag on the filter removed?
Remove the plastic bag from the filter before using.
• Is the filter order incorrect?
Check the order and direction of the filters
Please turn off the power immediately and contact
the maintenance department.
Deactivate automatic mode.
13