ELICA SHINING Montaje Y Modo De Empleo página 39

Control panel on hood
T1. Suction speed (power) control key.
Press repeatedly until the desired speed is selected,
choosing between:
Speed OFF – LED L1: off
Speed 1 (low suction) – LED L1: green light
Speed 2 (medium suction) – LED L1: yellow light
Speed 3 (high suction) – LED L1: light blue light
Speed 4 (intensive suction) – LED L1: light blue button
Note: Speed 4 has a limited duration of 5 min., and then the
hood passes automatically to speed 2.
T2. Light control key (hob light-dim light)
Press briefly to light up the hob
Keep it pressed longer to light up the dim light
Note: The dim light is only available on some models.
Grease filter saturation warning - LED L1: red light
The warning is visible for about one minute after switching the
hood off.
When this warning appears, the grease filter requires
maintenance.
Charcoal filter saturation warning - LED L1: red light
The warning is available for about one minute after switching the
hood off.
When this warning appears, the charcoal filter requires
maintenance.
Deactivation/activation of charcoal filter saturation
warning:
This warning is normally activated, to deactivate it:
with the hood off, press the keys T1 and T2 simultaneously
for more than 5 seconds.
LED L1 lights up red (signal on) and then begins to flash
(signal off).
Repeat the operation if you want to reactivate the signal.
LED L1 will switch from flashing red (signal off) to remaining
lit (signal on).
Filter saturation warning reset
With the hood off, press the keys T1 and T2 simultaneously for
at least 5 seconds. The LED L1 will stop signalling saturation.
Repeat the operation in case of simultaneous warnings of both
filters.
Pairing the remote control
Once the remote control has been successfully paired both LEDs
light up in several colours in sequence.
39