HAMPTON BAY 91315 Guía De Uso Y Mantenimiento página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Standard Ceiling Mount
1
Preparing for mounting
Remove the canopy ring (O) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (FF) located in the "L shaped
slots".
Remove and save the two canopy screws (GG) in the round
holes. This will enable you to remove the mounting bracket (A).
A
GG
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
Loosen, but do not remove, the setscrew (HH) on the collar on top
of the fan-motor assembly (E).
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
Re-tighten the setscrew (HH) on the collar on top of the fan-
motor assembly (E).
2
Routing the wires
Route the wires exiting the top of the fan motor (E) into
the decorative motor collar cover (D) and through the
canopy ring (O).
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
FF
C
O
B
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
O
B
D
E
C
D
DD
HH
E
HAMPTONBAY.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

91353

Tabla de contenido