Xtech FIERCE Manual Del Usuario página 3

Control
This screen displays the selected input mode:
1. LED display
Bluetooth , USB, Aux, MicroSD™ and FM, the volume
®
level, the track being played, and the selected channel.
Note: Remove the plastic film protector from the LED
display before using the loudspeaker.
2. USB port Enables audio playback from MP3 and WMA music files
stored in a USB flash drive.
3. MicroSD™ (TF) Enables audio playback from MP3 and WMA music files
card slot stored in a MicroSD™ card (maximum 32GB).
4. Media panel Allows the selection and control of the available audio
sources. Line-In, Bluetooth
tuner. The mode symbol lights up when the selected
source is being played (USB, BLUE, SD, LINE).
4a. Mode/LED Press this button to cycle through the different audio
button modes: Line-In, Bluetooth
Note: the USB and SD™ sources need to be connected
to be recognized by the unit to follow this sequence. If
these sources are not connected, they will not be
recognized as an input source on the display.
Press and hold this button to turn ON/OFF the LED lights.
4b. Button In USB, MicroSD™ or Bluetooth
button to start and pause media.
In FM mode, press and hold to initiate the scanning of
channels from the lowest up to the highest frequency,
and store them automatically as presets in the memory.
This button doesn't work in the auxiliary mode.
4c. Previous track Press this button to select the previous track on your
button play list. Available in Bluetooth
FM tuner modes.
In the FM tuner mode, press this button briefly to tune to
the previous station.
Press and hold this button to decrease the volume.
This button doesn't work in the auxiliary mode.
Description
, MicroSD™, USB and FM
®
, FM, USB and SD™.
®
mode, press this
®
, MicroSD™, USB and
®
Control
Press this button to select the next track on your play
4d. Next track
list. Available in Bluetooth
button
tuner modes.
In the FM tuner mode, press this button briefly to tune to
the next station.
Press and hold this button to increase the volume.
This button doesn't work in the auxiliary mode.
Use this knob to control the master volume level of the
5. Volume knob
speaker. Turn it clockwise to increase the volume or
counterclockwise to lower the volume level of the
speaker.
This ¼in microphone input will be used to connect a
6. ¼in Mic input
wired microphone.
jack
Connect a CD player, digital media player, a mobile
7. Aux input
phone or other audio source to this 3.5mm stereo line-in
connector.
Use this switch to turn the speaker on or off.
8. Power On/Off
switch
Use this port to power the unit and/or to charge the
9. DC 5V/1A
battery of the loudspeaker.
micro USB port
The LED light will turn red to indicate that the battery is
10. Battery status
being charged. It will turn green when the battery is fully
LED indicator
charged.
Description
, MicroSD™, USB and FM
®