Technical Assistance; Assembly Instructions; Holders; High-Pressure Hose - VITO PRO-POWER WR2 130B LITE Manual De Instrucciones

Hidrolimpiadora alta presion
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Keep all nuts and screws well tightened in order to
ensure a safe operation.
Always keep warning and indication stickers clean and
legible.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately.
A power tool with double insulation does not need to
be grounded. The maintenance of this type of
appliances requires extreme care and knowledge, and
should only be performed by a qualified technician. The
components replacement of a double insulated
appliance must be carried out with the same parts as
the original ones.
Use only VITO-approved accessories for this high-
pressure washer or technically identical parts. Not
doing so may result in personal injuries or damages to
the appliance. In case of doubt, lack of knowledge or
resources, you should contact an official dealer.

Technical assistance

Your washer should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.

ASSEMBLY INSTRUCTIONS

Holders

1. Fit the gun holder (4) and the gun set holder;

High-pressure hose

1. Insert the spray gun into the hose coupling (5), by
tightening the thread;
2. Attach the other end of the hose to the appliance;
Never start the high-pressure washer without first
unwind completely the hose. When operating, the hose
must not roll.
Keep the high-pressure hose away from heat
sources, sharp objects and abrasive edges
(corners, steps or rough floors). Worn out hoses can
cause damage.
Check the hose condition regularly and replace it, if
damaged. Do not attempt to repair a leaky hose.
30

Gun set (gun+lance)

1. Fit the lance to the spray gun (6);
2. Push the lance against the spray gun and fasten it by
turning clockwise.

Connection to water supply

1. Connect the hose to the water supply tap;
2. Open the water supply tap to remove any debris that
may exist in the hose. When water comes out clean,
turn off the tap;
3. On the other end of the hose, place the quick release
coupling;
4. Remove the cover in the water inlet filter;
5. Screw the water inlet filter (1);
6. Fit the hose connector in the water inlet filter;
7. The water inlet filter must always be installed to filter
out sand, and other impurities as these will damage
the pump valves.
The water supply should preferably be provided by a
hose connected to a tap of the water supply system.
It is recommended the use of a garden hose with
½"diameter and a minimum length of 5 m.
If you want to draw water from wells, tanks or other
type of water containers, you must install an additional
filter (hose suction filter) to prevent sand or other type
of waste intake.
In any of these situations, make sure that the inlet water
pressure is less than 4 bar.

OPERATING INSTRUCTIONS

While using the pressure washer, certain precautions
and procedures should be considered in order to avoid
accidents:
▪ Place the appliance in a stable surface and away from
the cleaning area;
▪ Do not use the power cord or high-pressure hose to
transport the high-pressure washer;

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Viml130wr2lite

Tabla de contenido