Publicidad
Idiomas disponibles
Idiomas disponibles
18.- Now take the weight selector tube
(22), Fig.12, and attach the holding
collar (33) for the first weight and
insert the lockpin (32).
Fit the last weight (30) onto the bars.
Fit the spacers (94) and by inserting
the bushes (95) tighten the bolts (76)
for the guide post (7) to the main body
(4), as shown in Fig.12.
FITTING THE CABLE SYSTEM.
19.- First check that the steel cables
are correctly fitted into the pulleys that
are supplied prefitted, following the
arrows in Fig.13.
Fit the plates (18) onto the pulleys
(45) as shownh in Fig.13A.
Position the upper body cable (47)
onto pulley (46) Fig.13B, insert the
pulley into the main body support (4),
Fig.13B, and tighten using bolt (75),
washer (85) and nut (91).
Next, attach one end of cable (49)
to the left arm plate for the Butterfly
exercise, Fig.13C, fit bolt (74) with
washers (85) and nut (91).
Do the same with the other end of
cable (49) for the right Butterfly
exercise arm.
The weights have already been
fitted into their housing in the previous
assembly step.
Lift the first weight (30) and fit the
weight selector post (22), as shown in
Fig.13D.
Screw bolt (47A) into the selector
post (22), when it is screwed in, lower
the weight so that it rests on the other
weights.
Insert the weight selector pin (44)
into the selector post (22), Fig.12, and
tighten nut (U) securely, Fig.13E.
Take the end of the foot pull-up
cable (48) and by following the arrows
marked on the cable, Fig.13, pass it
through the first pulley (A1), as shown
in Fig.13.
Next, pass the same tip through
lower pulley (B1; C1) Fig.13.
Continue passing the tip of the
cable (48) through the third pulley (D1)
Fig.13. Attach the end of the cable to
the carabiner (36) and to chain (34),
position it on the end joined to the
support on the base, Fig.13.
Note: After a while you may notice
that steel cable slackens a little due to
the cable settling into position.
To remedy this just tension the steel
cable by changing the chain link (34).
20.- Attach the top casing (28) fitting it
over the upper body (1) so that it slots
onto the main body (4) Fig.14.
Fasten on using screws (69).
REAR PROTECTION
ASSEMBLY.-
21.-Place the fixing points (98) in the
mesh (99) as shown in Fig.15.
Then, position the fixing points (98) on
the main body (4), place the screws
(70), with washers (84) and tighten, as
shown in Fig.16.
22.- Fit the chain (35) onto the leg
accessory hook (14) Fig.14, to be able
to do the leg exercises.
23.- Set the selector (40) as shown in
Fig.14 to be able to do the Butterfly
exercise.
33
Publicidad
