General Maintenance; Maintenance - Ryobi JS550L Manual Del Operador

wARNINg:
Failure to unplug your saw could result in accidental start-
ing causing possible serious personal injury.
 If the laser guide is on the right side of the line, turn the
laser adjustment screw counter clockwise one half of a
turn.
wARNINg:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
wARNINg:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.

gENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
wARNINg:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
NOTE: FIgURES (ILLUSTRATIONS) START ON PAgE 14 AFTER
All manuals and user guides at all-guides.com
ADJUSTMENTS

MAINTENANCE

FRENCh AND SPANISh LANgUAgE SECTIONS.
 If the laser guide is on the left side of the line, turn the
laser adjustment screw clockwise one half of a turn.
 Plug saw into power supply.
 Pull the switch trigger just enough to light the laser guide
to check for position.
 Repeat above steps if necessary.
Electric tools used on fiberglass material, wallboard, spack-
ling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes, com-
mutators, etc. Consequently, we do not recommend using
this product for extended work on these types of materials.
However, if you do work with any of these materials, it is ex-
tremely important to clean the product using compressed air.
LUbRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
POwER SUPPLy CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
13