HoMedics enviraScape SILVER SPRINGS WFL-SLVS Manual De Instrucciones Y Garantía página 4

5. Fill FOUNTAIN BASE (K) with enough clean water to completely cover the
WATER PUMP (F). Use the Fill Line as a guide. (Figure 5)
6. Place RIVER ROCKS (J) as desired on (A), (B) and (C), as well as
in the FOUNTAIN BASE. (Figure 6)
7. Attach the ADAPTER (I) to the POWER CORD (G).
8. Plug the cord into 120V household outlet. The fountain is controlled by an
ON/OFF SWITCH (H) located on the POWER CORD (G). If WATER PUMP (F)
does not operate, rotate in-line switch once to turn "ON" and once to turn "OFF".
NOTE:
Ensure that the POWER CORD loops below the electrical outlet to form a
"Drip Loop". This will prevent water from running down the POWER CORD into
the electrical outlet. (Figure 7)
Figure 5
Fill Line
Figure 7
Drip Loop
Figure 6
Stones
6
+
Figure 8
Impeller
Pump Inlet
Front Plate
Flow
Control
Lever
Maintenance
• To clean the pump:
Unplug from electrical outlet. Disassemble the fountain and remove the 2 screws
at the top of the Pump Cover (E) using a Phillips head screwdriver. Grasp the
Water Supply Hole and gently lift the Pump Cover to gain access to the Pump.
Remove the Pump Cover at the Water Supply Connector. Use a small brush or
stream of water to remove any debris (Figure 8).
CAUTION:
All servicing of this fountain must be performed by authorized
HoMedics service personnel only.
PVC Tubing
Inserts Here
Back Plate
Housing
Suction Feet
7