Power Connection; Getting Started; Time And Calendar Manual Setting - Denver CR-416 Instrucciones De Uso

PM Indicator
SANDBYIndicator
ALARM 1Indicator

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit
is equipped with a battery back up system, it requires a 3V CR2032
flat lithium battery (not included). Insert the battery in the battery
compartment, making certain that the positive and negative (+ and -)
battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the
clock automatically switches to the battery power supply, the clock and
timer memory continue running. When the AC power resumes, the clock
switches back to AC again.

GETTING STARTED

Press the RESET button (13) locates on the back of unit after AC plug
in.
- The unit will display full segment for 2 seconds, then it will enter the
normal mode.

1. TIME AND CALENDAR MANUAL SETTING

A. Setting Time and Calendar – Press Time set button (5) in normal
mode and keep depress over 2 seconds to enter time set mode,
after enter the setting mode, press Time set button (5) to change the
mode cycle as follows :
Normal → Year → Month → Day → 12/24 H → Real time Hour → Real
time Min → Normal
Action (during data adjustment):
- Press << / Tune -button (6) to adjust data backward.
- Press >> / Tune + button (7) to adjust data forward.
- Keep depress << or >> button for 2 seconds to enable auto forward.
LED DISPLAY
TIME Indicator
MHz Indicator
ALARM 2 Indicator