Radio - entrematic Ditec E1A Manual De Instalación

7.

Radio

Receiver
PRG
1
by installing the tuned BIXAL antenna.
NOTE: to connect the external antenna to the control panel, use a coaxial cable type RG58 (max 10 m).
Check that the storage module is inserted on COM connector of the control panel.
Up to 200 remote controls can be stored in the storage module.
WARNING: if the radio receiver on the control panel is not used, set JR3=OFF and remove the
storage module.
Transmitter storage:
- press the PRG button on the radio receiver or on the control panel; the SIG LED lights up;
- make a transmission by pressing one of the desired CH buttons of the transmitter (within the
range of the radio receiver). The transmitter is now stored. During this phase, the SIG LED
flashes. When the SIG LED is again lit up, it is possible to validate another transmitter. Validate
all the new transmitters by making a transmission as indicated;
- you automatically exit the procedure 10 seconds after the last transmission, or you can press
the PRG button again (the SIG LED goes off).
Up to four CH keys of a single remote control can be stored:
- if only one (any) CH key of the remote control is stored, command 1-5 (step-by-step/opening) is
carried out;
- from two to four CH keys of a single remote control are stored, the functions matched with the
CH keys are as follows:
Transmitter cancellation:
- keep pressed for 3 s the PRG button on the radio receiver or on the control panel, the SIG LED
begins to flash;
- to erase all the transmitters from the memory of the radio receiver keep pressed for 3 s again
the PRG button;
- to erase a single transmitter, press one of the previously stored CH keys of the transmitter to
be erased;
- the cancellation is confirmed by the quick flashing of the SIG LED.
If the control panel is replaced, the storage module being used can be inserted in the new
control panel.
ATTENTION: the insertion and extraction of the BIXMR2 memory must be carried out in
the absence of a power supply.
i
For further information see the user manual for GOL series transmitters.
CH1 CH2
CH3 CH4
2
34
The control panel is
equipped with a radio
receiver with a frequency
of 433.92 MHz.
The antenna consists of a
rigid wire, 173 mm long,
connected to the ANT
10 s
clamp.
It is possible to increase
the range of the radio by
3
connecting the antenna
of the flashing lights, or