Functioning With Gps Antenna; Functioning With Afnor Code - Gorgy Timing RADIO TIMING Modo De Empleo

1.2.3. Functioning wItH GPS antEnna

► make sure the transmitter is plugged on a 230vaC power supply source and that
the antenna is connected. across the diode remains lit until receiving a valid signal
(about 10 minutes during the initial operation).
► Upon receipt of a valid signal LED flashes every seconds indicating a radio show
takes place.
► if the LEd on the front stays on and off constantly check the position your gPS
antenna.
► In the event of first installation you have the possibility of forcing the transmitter in
permanent emission by activating the switch number 7 in on position. the red Led
in the front face will stay lighted in this mode.
ATTENTION this mode is reserved only for the installation to test all
the receiving clocks. This mode must be removed by repositioning
the switch 7 on OFF once the installation is finished. The LED in
front flashes again in normal mode.
► if the installation mode is activated before the issuer has been synchronized least
once, time will be transmitted to the time base of the issuer will operate autono-
mously and have started at 0H00.00s.

1.2.4. Functioning wItH aFnOR CODE

► make sure the transmitter is plugged on a 230vaC power supply source and that
the antenna is connected. across the diode remains lit until receiving a valid signal.
► Upon receipt of a valid signal LED flashes every seconds indicating a radio show
takes place.
► In the event of first installation you have the possibility of forcing the transmitter in
permanent emission by activating the switch number 7 in on position. the red Led
in the front face will stay lighted in this mode.
ATTENTION this mode is reserved only for the installation to test all
the receiving clocks. This mode must be removed by repositioning
the switch 7 on OFF once the installation is finished. The LED in
front flashes again in normal mode.
MDE-RTnetwork-3076V1.3 19