Anchor point PAF185 with fall indicator
PAF185
EN 795:2012 Type A
CEN/TS 16415:2013
TABLE OF CONTENTS:
General ............................................................... 1
1.
2.
Overall dimensions of anchor point ................ 1
Time of usage .................................................... 1
3.
4.
5.
6.
7.
Warranty ............................................................. 4
8.
Identity Card ....................................................... 5
9.
1.
General
Anchor
point
compliant with EN 795 Type A and can be used for protection
of 3 users at the same time.
PAF185
Anchor
point
personal protective equipment to protect user against a fall from
a height, and cannot be used for lifting loads.
The device is made as AISI304 stainless steel cast
and aluminium sleeve ensuring free rotation of the device.
According to EN 795:2012 Type A static strength of
this anchor point is min. 14kN towards direction of force, and in
configurations as shown in Figure 1
The maximum load that could be transmitted in service
from the device to the static construction - 10 kN. This is the
actual force which the anchor point transfers onto the structure
to which it is attached when a fall occurs, with properly
connected personal fall protection equipment.
If the device is used as a part of a fall arrest system,
the user must be equipped with an element limiting maximum
PAF185
is
an
anchor
can
be
used
dynamic forces applied on user while arresting a fall to max. 6
kN.
Figure 1. Acceptable methods of installation of device
2.
Overall dimensions of anchor point
device
only
as
Figure 2. Overall dimensions PAF185
3.
Time of usage
Maximum time of usage of correctly operating devices
is unlimited.
Page 1 of 5