Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The
device
immediately and destroyed if it has been used to arrest a fall or
there are any doubts concerning its function.
NOTE: Maximum time of usage of the device depends on
intensity and environment of use. If the device is used in heavy
conditions,
being
with
water,
sharp
extreme of temperatures, it may be necessary to withdraw
the device after only one use.
4.
Periodic inspections
At least once a year, after every 12 months of use, it is
necessary to carry out periodic detailed inspection of the
device.
Periodic inspection shall be carried out by service point
authorized by the Manufacturer located at the following
address:
PROTEKT Grzegorz Łaszkiewicz
ul. Starorudzka 9
or
a
competent
trained in performing inspections of such equipment.
A trained person is a person who, based on own
specialized
and adequate experience, has sufficient knowledge in installed
protective
and
and is familiarized with applicable OHS regulations, guidelines
and generally acknowledged technical rules to such extent that
is
able
to
and correct application of protection devices.
After 5 years of use, it is recommended that periodic
inspections are carried out by the manufacturer of the
equipment or an entity authorised by the manufacturer to carry
out such inspections.
Before each use of the system check whether date of
the next inspection is not expired. Do not use the device after
this date. Before each use of the system visually check the
system for its integrity and technical condition.
If any defect or lack of integrity is found, do not use the
point.
If any doubts arise as for the use of the equipment,
please contact the manufacturer and never repair the
equipment on your own!
A system which has been used to arrest a fall must be
withdrawn from use immediately!
The system which has been used to arrest a fall may be
admitted for use again after a detailed inspection is carried out
by the manufacturer or an authorised service point.
When using the system, pay special attention to risks
affecting the protective equipment operation or the user's
safety, and in particular to kinks and rope movement on sharp
edges, oscillatory falls, electricity, influence of extreme
temperatures, equipment damage, adverse environmental
factors, chemical substances and contamination.
Neither modify, repair components of the system nor
replace them with non-original spare parts.
must
be
withdrawn
exposed
to
frequent
edges,
corrosive
93-403 Łódź
person
with
adequate
rescue
assess
safety
from
use
5.
Device marking
contact
substances,
skills,
a - serial number of device
b - manufacturer
c - date of manufacture
education
d - symbol of device
e - no. of standard
equipment,
f - number of users
g - read instructions before use
of
use
6.
Installation of anchor point
•
Before anchor point PAF185 is installed, it must
be stored in a place which is: clean, free from
any vapours of corrosive substances, and in
conditions preventing its mechanical damage. Also
please take into account environmental conditions
present in the place of installation which may
cause corrosion of anchor point and fasteners.
•
Installation of anchor point must be carried out by a
properly qualified and skilled person familiarized with
the instruction manual.
•
Follow general rules for use of personal fall protection
equipment in accordance with EN 795:2012.
•
Example installations are shown in Figure 4
Figure 3. Method of device marking
Page 2 of 5
Publicidad
Capítulos
Tabla de contenido
