Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE:
1. Before using your Stand Mixer, remove all packing material,
plastic, labels,
stickers or tags that may be attached
to the Mixer, Bowls or Attachments.
2. Before the first use of the Stand Mixer, wash the Flat Beater, Dough Hook, and
Stainless Steel Bowls in warm, sudsy water or in the dishwasher. The
Wire Whip should be washed by hand only. Rinse and Dry all thoroughly.
3. The exterior of the Stand Mixer should only be cleaned with a soft damp cloth,
then dried with a soft,clean cloth.
4. Place Stand Mixer on a dry, level, stable, surface such as a countertop or
table. Keep Mixer away from countertop edge. Be sure to leave plenty of room
around Air Vents at the rear of Mixer.
NOTE: Do not use abrasive
cleansers
or scouring
loads when cleaning
|
i
your
Stand Mixer.
NEVER immerse the body
of thb Stand Mixer
1
m water
or any liquid.
TILT HEAD
To insert and remove attachments
and bowls, it is necessary to raise the Tilting Motor
Head.
To raise Head, locate
the Locking lever on the left hand side. Pull lever forward
to the
Unlock icon _. Raise head and release lever. Lever will return to Lock icon i_. Push
head all the way back until it stops. Head is now locked in place.
To lower Head, pull lever forward
to Unlock icon. Release lever and guide Head
down until it locks into Mix position.
_
ARNING:
To avoid serious injury, never turn on Mixer with Beater or other
attachments connected unless the Bowl is in place.
WARNING:
To avoid serious injury, keep fingers and hands away from
beater attachment
hole and hinge area when raising or lowering
Tilt Head.
Publicidad
