Normal Operation - Alera ALE-HT3SAB Instrucciones De Montaje

Model: ALE-HT3SAB
CAUTION
Please orient the table so the plug (from the control box) is closest to the wall outlet
1. RESET ***PERFORM RESET BEFORE 1
• Press both and buttons at the same time until
both columns are in lowest position.
• Display will show "000" while conducting reset.
• When control box beeps, the buttons can be released
and reset is complete.
• The anti-collision feature will be functional after reset.
3. SETTING & USING MEMORY PRESET POSITIONS
• Operate the desk to preferred height.
• Press any of ① ② ③ ④ together with
2 seconds to store the current height. Display shows
P1/ P2/ P3/ P4 when the position has been stored.
• To return table/desk to a stored position, press the
memory preset button ① ② ③ ④ and the desk will
move to the stored height.
• Memory presents can be overwritten with a new
position at any time.
MEMORY CONTROL
OPERATING INSTRUCTIONS
USE***

2. NORMAL OPERATION

ST
• Press any button and display shows current height
in centimeters (cm).
• Press or
• When no button has been pressed for 30 seconds,
the system goes to <0.1 W standby mode, and the
display turns off. Press any button to wake the
system and display the current base height.
4. CHANGING STARTING HEIGHT
•The default starting height is 25.5".
or for •To adjust the starting height, press
reaching lowest position. At the lowest position,
press button again for 5 seconds until display
starts flashing for 10 seconds.
• During this time, press
height to preferred starting position, and then press
and buttons together for 3 seconds to store
this position.
• Display stops flashing and the new starting height is
shown in the display.
button to adjust the height.
button until
or buttons to adjust
4-Position Memory Control