Safety Tips; Service Information - Revell Control OUT SPEEDER Manual Del Usuario

TIP:
The car can perform flips in a tube with
a 20-40 cm diameter.
4. geNerAL DrIvINg TIPS:
• Always place the car on a flat surface.
• Always watch the car instead of looking at the remote control!
• Beginners should start by learning to control the car.
Always release the forward/turbo-buttons right away following a crash to prevent damaging
the electronics.
Problem:
The wheels won't turn.
Problem:
The wireless remote control
doesn't function.
Problem:
The car loses speed and
comes to a stop for no apparent
reason.
You will find more tips and tricks in the Internet under www.revell-control.de.
go to www.revell-control.de for ordering information and tips on replacing spare parts,
8
Cause:
• The battery is low or empty.
Cause:
• The batteries weren't inserted properly.
• The batteries no longer have sufficient energy (only the
left control LED lights-up/signal tone sounds-off).
Cause:
• The battery in the car is too low.

Service information

plus other useful information on all revell Control models.
The special effects that the car
commands will surprise those who
take the time to devise new types of
ramps. We hope you have lots of fun!

Safety tips

5. SuITABLe LOCATIONS:
The vehicle should be operated in an area that meets the following criteria:
1. You should choose a place with as much open space as possible, with no obstacles.
2. When starting the vehicle, make sure that there are no people or animals nearby.
3. Always watch the vehicle to prevent it from crashing into the driver or other
people or animals and causing injury.
Safety Tips
Troubleshooting
remedy:
• Recharge the battery (see Chapter
"Charging the car").
remedy:
• Check to make sure the batteries are
inserted properly.
• Insert new batteries.
remedy:
• Recharge the battery (see Chapter
"Charging the car").
www.revell-control.de