Power Sources - COLUMBIA VAC OPC 120 Manual Del Usuario

- Cooling pipes or components should be installed in a place where there is a low likelihood
of their coming into contact with any substance which can cause corrosion of components
containing refrigerant, unless these components are made of materials inherently resistant to
corrosion, or adequately protected against corrosion.
9. Electrical-equipment inspections
Repairs and maintenance of the electric components include preliminary safety inspections and
component-control procedures. In the instance of a fault which could risk safety, do not connect
the power supply to the circuit until it has been satisfactorily rectified. If the fault cannot be
rectified immediately, but further action is necessary, an appropriate temporary solution must be
implemented. This should be reported to the device owner so that all parties are informed.
Preliminary safety inspections include
- condenser discharge: should be done in a safe way to avoid the possibility of sparking;
- no covering of live electrical components or wiring when charging, recovering, or cleaning the
system;
- earthing continuity
SPECIAL RECOMMENDATIONS:
- Ambient temperature range for the device is 5°C -35°C.
- Install the portable air dryer on a flat location with a large space, without obstacles. Leave a
30cm minimum space between the unit and the wall.
- The device must be installed in accordance with national installation regulations.
- The plug shall be always accessible after its installation.
- Always place the appliance in a vertical position, in order to maintain the compressor in good
working condition.
- Do not tilt the device in any direction as spilled water can damage the device.
- Do not use the appliance near gas or other inflammable liquids.
- Do not block the air outlet and inlet ventilation. Do not place heavy objects on the device.
- Do not use spray (insecticides, painting) or any other inflammable products near the appliance
as the plastic case may be deformed. The unit may sustain electrical damage.

POWER SOURCES

- The plug has to be well fixed and should not be damaged.
- Do not plug in the appliance with an adaptor.
- Plug into the wall socket before switching on the appliance then press on the ON/OFF button.
23