Publicidad
DIP [SW1], switch 3 determines the playback mode, normal or cyclic.
DIP [SW1], switch 4 inhibits or enables recording memory.
DIP [SW1], commutateur 3 détermine le mode de lecture, normal ou cyclique.
DIP [SW1], passer 4 inhibe ou active la mémoire d'enregistrement.
DIP [SW1], interruptor 3, determina el modo de reproducción, normal o cíclico.
DIP [SW1], interruptor 4, inhibe o habilita la grabación de la memoria.
Selecting Audio Input : Jumpers JP2 and JP3 set the audio input for recording.
JP2 and JP3 closed circuit selected microphone.
JP2 and JP3 open determined to RCA connector for audio input.
Sélection de l'entrée audio : cavaliers JP2 et JP3 régler l'entrée audio pour l'enregistrement.
JP2 et JP3 circuit fermé microphone sélectionné.
JP2 et JP3 ouvrir déterminés à connecteur RCA pour l'entrée audio.
Selección de Entrada de Audio : Los Jumpers JP2 y JP3 establecen la entrada de audio para la grabación.
JP2 y JP3 cerrados seleccionan el micrófono del circuito.
JP2 y JP3 abiertos determinan al conector RCA como entrada de audio.
OPERATION : Common aspects of the recording / playback .
Provide the number of messages that shared memory before powering the circuit. Only you can make the recording and
playback of messages if they have been established by setting the dip [ SW1 ] .
When you change the configuration of the number of messages , reset circuit power . The inputs of the messages will be displayed
in operational employees .
Recording: The recording function is only possible if the dip switch 4 [ SW1 ] is ON .
Each recording of a message removes its previous contents .
To record :
- Close both input contacts [ REC] .
- Start recording and maintaining closed activating the corresponding input message.
- If you use the microphone circuit , approach to it. If you use the RCA input , be sure to turn your sound source .
- Free entrance to the message to stop recording . Otherwise , recording automatically ends upon reaching the time limit.
- To record again on the same or any other message , release the connection of the previous message , and repeat the process
from the point 2 .
- When you have completed recording operations restore the [ REC] entry releasing the connection of contacts.
In recording mode :
The REC LED illuminated indicates that the circuit performance is in recording mode.
The RUN LED lit indicates that recording is being recorded .
Playback : Playback is only possible if the [REC ] input is not selected.
To read a message:
- Close the input of the corresponding message.
- Playback automatically stops when the end of the record ( recording time ) , while being less than the time limit message. It will not
stop even before release input message.
- To play back another message after the previous stop playback, close the entry .
In operation with more than one message , if closed while several inputs are first played the senior . 1 being most important and 8
the lowest .
For looping a message :
- Set up the circuit in cyclic mode playback. 3 dip switch [ SW1 ] ON.
- Close and keep closed the entrance of the message.
- When playback reaches the end of the recording , automatically return to the beginning of this keeping the repeat loop .
- Playback will stop only when you release the message and after reaching the end of the log message .
- When resume operation with no cyclic reproduction set switch 3 of [ SW1 ] OFF.
www.cebek.com
- sat@cebek.com
TR-14
Publicidad
