Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
To reduce the risk o ffire, omectr c
shock,
or injury
topersons,
read t his e ntire
manual,
including the Important Safety Instructions, before operating this dryer.
* Unplug the dryer or turn the power off before cleaning to avoid the risk of electric shock. Failure to follow this
warning can cause serious injury, fire_ electrical shock, or death.
* Never use harsh chemicals, abrasive cleaners, or solvents to clean the dryer. They will damage the finish.
REGULAR CLEANING
Cleaning the Exterior
Proper care of your dryer can extend its life. The outside
of the machine can be cleaned with warm water and
a mild, nonabrasive household detergent, immediately
wipe off any spills with a soft, damp cloth.
IMPORTANT: Do not use cleaning alcohols, solvents, or
similar products.
NEVER use steel wool or abrasive cleansers because
they can damage the surface.
Cleaning
the interior
Wipe around the door opening and seal with a soft,
damp cloth to prevent lint and dust buildup that could
damage the door seal.
Clean the window with a soft cloth dampened
with
warm water and a mild, nonabrasive
household
detergent, then wipe dry.
NEVER Use steel wool or abrasive cleansers; they can
scratch or damage the surface.
Cleaning
Around
and Under
the Dryer
Vacuum lint and dust from around the dryer and
underneath it regularly.
ALWAYS make sure the lint filter is clean before every
cycle. The CHECK FILTER light on the control panel wil!
blink before every cycle to remind you.
NOTE: NEVER operate the dryer without the lint filter.
To remove ffnt between
cycles:
Open the dryer door.
Pull the lint filter straight up.
Roll any lint off: the filter with your fingers.
Periodic thorough
cleaning:
Some fabric softeners can build up on the lint filter over
time. This buildup can restrict the airflow through the
filter reducing dryer efflciency
and lengthening drying
times. After removing lint, if the filter looks dark or dirty
when held up to the light, follow these steps to clean:
Cleaning the Lint Filter
Lint Filter
t_!
Use hot soapy water and a stiff brush to clean
the filter.
Make sure the filter is completely
dry before
reinstalling it and using the dryer.
NOTE:
NEVER operate
the dryer
with a wet lint filter.
Maintaining
Ductwork
Vent ductwork
should be checked for lint build up once per
month and cleaned at least once per year. if any noticeable
reduction
in airflow
or drying performance
occurs, immedi-
ately check the ductwork
for obstruction
and blockages.
Con-
tact a qualified
technician
or service provider.
28
Publicidad
Tabla de contenido
