Tabla de contenido
Publicidad
Configuring the Router
The AR750S-DP comes with a simple default configuration
Default Configuration" on page
To further configure the router you can either:
"Configure with the Graphical User Interface (GUI)" on page
■
"Configure with the Command Line Interface (CLI)" on page 18
■
Configure with the Graphical User Interface (GUI)
This section describes how to access the AR750S-DP GUI via a switch port in
VLAN1, when the PC and the router are in the same subnet, in order to
configure the router. The router's switch ports all belong to VLAN1 by default.
We recommend starting to configure the AR750S-DP using the GUI. You can
then use the CLI if necessary to complete your configuration
the Command Line Interface (CLI)" on page
The GUI requires a PC and web browser. Supported browsers are Internet
Explorer 5.0 or later and Netscape 6.2.2 or later, with JavaScript enabled. If you
are using a toolbar or plug-in on your browser to block pop-ups, disable it while
using the GUI. The GUI displays detailed configuration options and information
in pop-up windows.
Caution If another device on your network already uses the router's default IP
address, 192.168.1.1, do not connect the router to the network until you have
changed the management port's address using the CLI.
1. Connect the PC to a router switch port.
The PC can be connected directly, or through your LAN.
•
To connect the PC directly to the router, use a straight-through Ethernet
cable to connect an Ethernet card on the PC to any one of the router's
switch ports.
AR750S-DP Router
AR750S-DP
Secure VPN Router
20).
ETHERNET
STATUS
ETHERNET
SWITCH PORTS
PIC
PSU 2
1
L/A
L/A
D/C
D/C
PSU 1
SYS
0
1
1
2
3
4
5
0
RESET
Switch Ports
Installation and Safety Guide
("AR750S-DP
18).
PC
SWITCH PORTS
CONSOLE
1
2
4
0
1
3
5
ASYN0
15, or
("Configure with
PIC1
PIC0
PIC BAYS
750S-DP_PC
15
Publicidad
Tabla de contenido
