Telephoning; Outgoing Calls/Exchange Line Request - Auerswald COMtrexx Advanced Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Telephoning

29. Open the page Exchange Lines > Exchange line request and locations. Configure
the location or locations of the PBX, the exchange lines and the end devices.
30. Open the pages of the folder Exchange lines. Enter the settings according to the
existing provider.
31. Open the page User > Phone numbers. Configure the phone numbers for the users.
32. Open the page Administration > Network > Server services. Activate the function
Auto provisioning active.
Note: Make sure that there is only this PBX in the network when activating auto
provisioning.
33. Switch on the telephones. After successful auto provisioning, the telephones are
displayed under Telephones > Assignment.
34. If required, open the pages of the folders Internal Devices and External Devices.
Configure the internal and external devices.
35. Assign the end devices to the users.
Telephoning

Outgoing Calls/Exchange Line Request

When dialling phone numbers, the exchange line request type configured for the user must
be noted. The PBX distinguishes two types of exchange line requests:
Automatic exchange line request (factory setting): Neither for the internal nor for the
external number a prefix is required. The PBX automatically distinguishes between internal
and external numbers with the adjustment of the dialled phone number and the internal
numbering plan:
If the phone number is contained in the telephone numbering list, the PBX establishes
an internal connection.
If the phone number is not contained in the telephone numbering list the PBX establishes
an external connection.
Note: To avoid conflicts between 3 or 4 digit phone numbers of the local area network
and the internal numbering plan, phone numbers of the local area network should
always be dialled with local area code.
Note: Also when the entered phone number correspond with the internal telephone
numbering plan, the PBX waits up to 4 seconds for whether additional digits for an
external number are being entered, before it dials the internal phone number. To avoid
waiting time, you can subsequently enter #. The PBX therefore recognises the input
as finished and instantly starts dialling.
Internal telephone: The user has to dial an external number with preceding exchange line
access number.
14
COMtrexx Advanced - Firmware V1.4 - Instructions V02 06/2021

Publicidad

Tabla de contenido
loading

Tabla de contenido