Assembling The Ventilation Shaft; º Outdoor Evacuation - De Dietrich DHD1193W Manual De Utilización

EN 2 / INSTALLING YOUR APPLIANCE
•
ASSEMBLING THE VENTILATION
SHAFT
•Outdoor evacuation
— Using the two screws (fig. 1), attach the met-
al chimney bracket against the wall, flush with
the ceiling for support.
— Mount the back-flow valve near the motor
outlet (fig. 2). This back-flow valve makes it
possible to block the entry of air from the out-
side.
— If a 125 mm flue is being installed, use the
adapter provided (fig. 3). If the diameter of
your exterior flue is less than125 mm, you
must connect your hood in recycling mode.
— Slide the end of the flue over the motor out-
let (fig. 4).
— Prepare your telescoping ventilation shaft,
taking care not to block the vents (B/fig. 4).
Fit the chimney to the hood and lift the upper
portion to adjust the height and then screw it
(G/fig.4) on the metal chimney bracket (A/fig.
4).
C C h h i i m m n n e e y y b b r r a a c c k k e e t t
A
B T T e e l l e e s s c c o o p p i i n n g g v v e e n n t t i i l l a a t t i i o o n n s s h h a a f f t t
F F l l u u e e
C
A A d d a a p p t t e e r r
D
B B a a c c k k - - f f l l o o w w v v a a l l v v e e
E
M M o o t t o o r r o o u u t t l l e e t t
F
C C h h i i m m n n e e y y h h o o l l d d i i n n g g s s c c r r e e w w
G
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
150 mm-diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In the
event that the hood will be operated using
outdoor evacuation, you should ensure a
sufficient inflow of fresh air to avoid a pres-
sure deficiency in the room.
fig. 2
A
C
D
E
F
26
fig. 1
fig. 3
B
G
fig. 4