Installing The Wall Mounting Arm - Dräger Polaris 50 Manual De Usuario

D
Insert wall bracket "A" (with end ring "C" and cover "B" in

position) into the wall holder "D" and simultaneously pull
the plug through the rectangular cut-out.
E
F

When the wall bracket is vertically aligned, install it with
the M8 locking screw and nut "E" and tighten (20 Nm).
Tighten all 4 grub screws "F" (5 Nm).


Connect the ceiling tube plug to the power supply plug.

Push the cover against the wall and screw tightly with the
ring (0.5 Nm)
C
B
A
4.3

Installing the wall mounting arm

WARNING

Risk of injury if the spring-balanced arm should jump

Do not remove the transport guard until after the
luminaire head has been installed.
B
A
C
Carefully loosen the cover "A".

Loosen the screws "C" and remove the joint covers "B".

D
Carefully remove the rotary plug "D".


Install the wall mounting arm.
ENG
A
31