SUOMY City Tour Instrucciones De Uso página 23

Make sure the padding has been fitted correctly by verifying:
- The correct positioning of the strap, which must pass above the lower end of the cheek pad.
- That the cheek pad is tightly fixed to the helmet.
CHEEK PADS – Removing the fabric lining – see figure 7
Removing the cheek pads: Lift the shaped plastic strap on the back part of the cheek pad, until the Velcro closure is completely detached.
Slide out the fabric lining from the padding.
Fitting the pads: Fit the lining on the padding starting from one of the ends, and then fit it on the opposite side. Verify that the lining is correctly
applied to the padding so that it fits tightly without folds. Stretch the fabric and press the shaped plastic flap on the fabric in order to fix the lining
with the Velcro closure, under the flap itself.
VISOR
The visor must be cleaned and controlled. If the visor is dirty and/or has bad scratches on the surface there could be unusual light reflections
or deviations, which may jeopardize safety. Immediately replace the visor if there are such problems.
How to operate – see figure 8
Use the lower and upper edges of the visor to open. Do not open it using other areas to avoid causing accidental damages (scratches or lines)
or dirtying the field of vision.
figure 7
A
USER'S INSTRUCTIONS
Eng
figure 8