USER'S INSTRUCTIONS
Eng
There are two locking positions when the visor is completely closed or completely open.
When the visor is opened it must be pushed up to the locking position. When the visor is correctly locked it clicks into position. To unlock the
visor from the locking position, by following the operations mentioned above, just push a bit during the initial movement until it is unlocked from
the locking position.
While riding the motorcycle the visor must never be left in the intermediate positions, it must always be locked in the locking positions.
Removing the visor: - see figure 9
Open entirely the visor up to the locking position; from this position operate on the release lever (H) of the visor mechanism under the side covers.
Move the lever (H) in position (B). Remove the cover by rotating the back part outward and then sliding it out of the fastening holes on the visor
fastening holes. Repeat the operations on the opposite side.
Move the lever (H) in position (C). Remove the visor form the mechanism. Repeat the operations on the opposite side.
Fitting the visor: - see figure 10
Verify that both levers (H) of the mechanism are in position (C). Position the side end of the visor on the mechanism so the holes (K-S) of the
visor match the flap (W) and the pin (X) on the mechanism.
Lightly press on the ends of the visor and bring the lever (H) in position (B). Repeat the operation on the opposite side.
H
figure 9
22
H
K
J
Z
X
H
T
W
H
Z
T
U
Y
X
figure 10