Easy Roomside Installation - REVENT RVS50 Guia De Instalacion

SheetLock
Installation
Watch the video: REVENTFANS.COM/INSTALL
WARNING: Disconnect all AC Power Breakers or Fuses before attempting
to cut into your ceiling.
1.) Place the provided sheetrock cutout TEMPLATE on ceiling where you wish the
FAN to be (DAMPER and electrical positions shown on TEMPLATE). We suggest
using painter's masking tape to hold the template in place while cutting. If there is a
pre-existing fan opening, use aligning windows to find it's edges. Either cut through
the provided guide slots in the TEMPLATE, or mark your cut lines with a pencil and
remove the TEMPLATE. Use a sheetrock jab saw to cut your fan opening in the
ceiling.
sheetrock jab saw
2.) Use a flathead screwdriver to raise the DAMPER away from the notch in the
FAN body, then slide the DAMPER up half way until the notch in the side of the
DAMPER aligns with the upper set of guides. Remove the DAMPER from the FAN.
Remove
DAMPER
from FAN
at notch
®
flathead
screwdriver
DAMPER
Easy Roomside
TEMPLATE
8
guide
notch
guide
FAN