Installation Steps - Planet POE-161S Manual De Usuario

Installation Steps:

1. [Switch & 802.3at PoE+ Injector] Connect a standard network
UTP cable from a switch/workstation to the "Ethernet" port of the
802.3at PoE+ Injector, which gets DC power from the attached
power adapter.
2. [802.3at PoE+ Injector & 802.3at PoE+ Splitter]
 Connect a long UTP cable between the "Ethernet+DC" (or
"PoE") port of the 802.3at PoE+ Injector and the "PoE IN"
port of the 802.3at PoE+ Splitter.
 The PoE LEDs of both the 802.3at PoE+ Injector and 802.3at
PoE+ Splitter will light up continuously.
3. [802.3at PoE+ Splitter]
 Connect the UTP cable in the package from the "Ethernet" port
of the 802.3at PoE+ Splitter to the RJ45 port of a remote
device.
 Properly adjust the DC power output and connect the DC plug
from the "DC OUT" of the 802.3at PoE+ Splitter to the remote
device.
Switch
Data
AC
Power
PoE
Figure 4: 802.3at PoE+ Injector and 802.3at PoE+ Splitter Architecture
Please ensure the 802.3at PoE+ Splitter output voltage
is correct before supplying power to a remote device;
otherwise, it may damage the remote device.
Note
100 meters
POE-161S (
Data Power
PoE
802.3at PoE+
Injector
1000BASE-T UTP
1000BASE-T UTP with PoE
Power 5V/12V)
POE-162S (
CAUTION CAUTION
Incorrect voltage might Incorrect voltage might
cause device damage cause device damage
5V 12V 24V
Power
802.3at
PoE+ Splitter
Power Line (AC)
AC
Power Line (DC)
DC
Power 24V/12V)
12V
Data
DC
PTZ Speed
Dome
1-5