medi M2 Active OA Instrucciones De Uso página 4

English
M2 Active OA Light
• The straps at the back have already
been set by the technician. (Figs. 5 and
Knee Brace
6)
• Take a few steps and ensure that the
brace is sitting correctly on the leg. If
necessary, correct the position of the
M2 Active OA Light Knee Brace
brace again. (Fig. 7)
Taking the brace off:
• Open both of the straps and stick the
end of the straps back onto their
respective straps, to prevent them
from snagging clothing. (Fig. 8)
• Open the velcro fastening on the brace
and pull it off your leg, moving
downwards. Close the velcro fastening
to prevent damage from occurring.
(Fig. 9)
Note for technicians:
• Set the load relief system (strap
system) so that the patient attains a
good level of pain relief. The base
setting should be set so that the
patient can still increase or decrease
pressure. Excess strap material can be
trimmed away as needed after initial
fitting. (Fig. 10)
• Allow the patient to wear the brace for
a few minutes to ensure that the
straps are providing an appropriate
and comfortable level of tension.
Care instructions
Velcro fasteners should be closed for
washing. Soap residues, lotions and
ointments can cause skin irritation and
material wear.
• Wash the product by hand, preferably
using medi clean washing agent.
• Do not bleach.
• Air dry only
• Do not iron.
• Do not dry clean.
    
Storage instructions
Keep the product in a cool, dry place.
Material composition
Polyamide, poliurethane, polyester,
lycra, aluminum
Liability
The manufacturer's liability will become
void if the product is not used as
intended. Please also refer to the
corresponding safety information and
instructions in this manual.
Disposal
The product can be disposed of in the
domestic waste.
Before each use:
Your medi team
Wishes you a speedy recovery!
r
P
r