Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Installation
Install rack handles
1
(supplied) and mount
UPS in standard
19 in. rack using
standard rack hardware
(user supplied).
Install your UPS in the lowest rack position
possible.
Plug your UPS into
2
an electrical outlet.
Your UPS should occupy a 15-amp dedicated
circuit.
Plug your equipment into
3
your UPS.
Your UPS is designed to support only computer
equipment. Connecting household appliances,
laser printers or surge suppressors is not
recommended.
Turn your UPS ON.
4
Set the System Enable Switch to the
"ENABLE" position.
This switch activates the battery charger and
microprocessor.
The "XXX" light will flash until you engage the
ON/Standby Switch to activate the "ON"
mode.
Engage the momentary ON/Standby
Switch (UPS front panel) and release it
to activate the "ON" mode and supply
power to the UPS receptacles.
System Enable Switch
Located on Front Panel
("I" = ENABLE;
"O" = DISABLE)
ON/Standby Switch
Located on Front Panel
3
Publicidad
