Power Indicator; Installing Batteries - Bushnell LYNX 260401 Manual Del Usario

GETTING STARTED

Installing Batteries

This device operates on two AAA batteries (alkaline or lithium). To install, rotate
the battery cover in a clockwise direction, to the "open" position as shown in
the lower right photo. Insert the batteries into the battery compartment so that
the positive (+) and negative (-) terminals of the batteries facing you match the
markings above the OPEN arrow ("-" on left side, "+" on right side). Replace the
battery cover carefully, rotating it counter-clockwise back to the closed position.
Use and Testing
Make sure the batteries have been installed according to the instructions above.
If you wish to test your night vision device in a lighted area, be sure the
objective lens caps are covering both objective lenses prior to pressing the
"ON" button. The objective lens caps have a pinhole opening to admit a small
amount of light for testing purposes.
If testing or using the device in the dark, remove the objective lens caps and
activate the device by pushing the "ON" button. The power indicator LED above
the battery cover will light.
To focus, select an object at the approximate distance for the area that you
intend to view. Adjust each eyepiece diopter setting until the image appears the
sharpest for your eyesight. After your initial diopter setting, the front (objective)
lenses are now utilized for focusing: adjust the front lenses clockwise when you
need to focus on closer objects, counter clockwise for more distant objects. If
you are unable to focus on very close objects, the eyepieces may then be used
as well for fine adjustments only.
6

Power Indicator

Battery Cover
Closed Position
Battery Cover
Open Position