CleanForce CF1800HD Manual De Referencia página 11

aSSEMBLY aND OpEraTION INSTrUCTIONS
OFF
Make sure the ON/OFF switch is on
the OFF position before plugging in
the unit, press the switch button with
mark " O " to ensure it is off.
Ensure the gun safety latch is
released by pushing it down and
engage the trigger for a few seconds
to discharge the residual pressure in
the high pressure hose.
Depress the gun trigger until there is a steady stream of water. Change the
spray tip as per the recommendation above if necessary. Before changing
spray tip, switch the machine off, depress trigger to release pressure and
activate gun safety latch.
Completely unwind power cord by
pulling and plug the Ground Fault
Circuit Interrupter (GFCI) into a power
outlet. Indicator should turn red. TEST
BEFORE EACH USE. Press the
"TEST" button. Red indicator should
disappear. Press "RESET" button
again for use. Do not use if above test
fails.
Turn ON the pressure washer by press-
ing the button with mark " I ". The unit
will run for a few seconds to build up
pressure, then will stop on the function
of total stop system (TSS).
10
ON