Shutting Down And Storage - CleanForce CF1800HD Manual De Referencia

1. (If you are not using detergent, go directly to Step 2.) When you have finished using
the detergent dispensing system, fill detergent tank with clean water to rinse the
system clean. Depress the gun trigger for one minute at low pressure so that all
detergents remaining in system are thoroughly flushed out. Remove detergent tank to
empty the remaining water, and rinse it until it is thoroughly cleaned.
2. Turn off water supply and disconnect the garden hose from the faucet and the water
inlet on the unit.
3. Depress the gun trigger for a few seconds to release any remaining water until water
spray stops, turn off unit immediately.
4. Unplug the Ground Fault Circuit Interrupter (GFCI) from the power outlet and wrap
power cord into the cable reel by rotating the reel with hand crank.
5. For storage, disconnect the high pressure hose from the gun wand and wrap hose
into the hose reel by rotating the reel with hand crank.
6. Engage gun safety latch and disconnect the quick – connect wand from gun wand,
disassembly and replace the spray tip to tip holder on the unit, insert the wand into
the wand holder, turn back the hand to the down position.
7. Store the machine and accessories in a room that does not reach freezing
temperatures. Do not store near furnace or other sources of heat as it may dry out the
pump seals.
Warning
Turn off water supply and squeeze trigger to depressurize the unit.
Failure to do so could result in personal injury due to discharge of
high-pressure water.
Optimum Winterizing Procedure
Winterizing your pressure washer will help protect and prolong its life. We strongly
recommend you follow the below steps using *Pressure Washer Pump Saver.
This will keep the internal parts lubricated, protected from rust, and prevents the pump
from freezing.
*Pressure Washer Pump Saver
not included
SHUT DOWN aND STOragE
1. Connect Pressure Washer Pump Saver
hose onto the water inlet.
2. Depress button on top of pump saver
container.
3. Continue until fluid exits the pressure hose
for 15 seconds.
4. Remove the hose from pump inlet (water
inlet).
14