Pump Maintenance - Bestway SIZZLIN' COOL Flowclear Manual Del Usuario

NOTE:
It is important to ensure all elements: Hoses, Debris Screens and Inlet/Outlet Valves are properly aligned.
Operation
1) Open/unscrew the Air Purge Valve (P6112) on the top of the Filter Pump; air is released as water fills the Filter Pump.
NOTE:
If knob should become dislodged, simply place it back into the hole and turn clockwise to rethread air purge valve.
2) When water comes out of the Air Purge Valve (P6112) screw it closed and wipe away any water.
3) Test the GFCI plug.
NOTE:
It is imperative to check that the hydraulic connectors are not closed.
GFCI Test
A
A. To test the GFCI plug, insert it into a grounding type receptacle.
B. Press the "RESET" button; the indicator turns red.
NOTE:
If the indicator light is not on, the test has failed.
C. Press the "TEST" button. The indicator turns off.
NOTE:
If the indicator light is not off, the test has failed.
D. Press the "RESET" button, the indicator light turns red, and the filter pump is ready for use.
WARNING:
RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED BEFORE EACH USE.
WARNING:
DO NOT USE THE PUMP IF THE ABOVE TEST FAILS.
Please contact your local Bestway Aftersales Service (the recommended 3rd party support for SIZZLIN' COOL Flowclear™
Filter Pump).
NOTE:
To prevent the risk of electrical shock, ensure your hands are completely dry when plugging-in the Filter Pump.
IMPORTANT:
covered by water before operating the Filter Pump.

PUMP MAINTENANCE

CAUTION:
YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY MAINTENANCE OR STORAGE
BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS.
1) Unplug the Filter Pump.
2) To stop water flowing to the Filter Pump, refer to pool's manual.
3) Unscrew the Filter Cap Retainer and remove the Filter Cap.
4) Clean the Filter Cartridge with a garden hose. If filter cartridge remains soiled or discolored, it is necessary to replace it with a new one.
5) Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump.
6) Check that the Filter Cap Seal is in place.
7) Replace the Filter Cap and screw the Filter Cap Retainer into position.
8) Open the Valve A and B.
9) Follow the PUMP INSTALLATION DIRECTIONS section to prepare the system for use.
IMPORTANT:
suggest replacing the Filter Cartridge with a new one every two weeks.
PUMP STORAGE
1) Unplug the Filter Pump.
2) Stop water flowing into the Filter Pump and to remove the Filter Cartridge.
3) Discard the Filter Cartridge.
4) Detach all Hoses.
5) Dry all components thoroughly.
6) Store the filter pump in a dry location out of the reach of children. Storage temperature: 4-40
7) Drain the pool according to the Pool Owner's Manual.
Pump Warranty: For information concerning pump warranty please visit SIZZLIN' COOL'S official 3rd party representative's
website at: www.bestwaycorp.com
B
RESET
TEST
DO NOT DRY RUN THE FILTER PUMP - Make sure both the pool's Inlet and Outlet valves are fully
To ensure pool water stays clean, please clean the filter cartridge every day. For sanitary reasons we
C
RESET
TEST
6
RESET
TEST
F)
C (39.2-104
O O
D
P-S-004851