Operation; Emptying The Filter Base - Kokido EV80 Manual De Usuario

OPERATION

WARNING!
 Make sure the pool vacuum is off
 Do not use the pool vacuum if any damage is detected.
 Oil stain could occur due to possible leakage of lubricants applied to the
O-ring.
 Do not operate this pool vacuum if there are people/pets present in the
water.
 Make sure the pool vacuum is fully immersed in the pool before initiating
operation. The minimum water level required to operate the pool
vacuum must reach above the power ON/OFF switch of the pool
vacuum when it is held in a vertical position. Operating the pool vacuum
when it is not immersed correctly could damage the unit and void the
warranty.
 DO NOT use the pool vacuum without an intact filter screen in place.
Using your pool vacuum without an intact filter screen in place will VOID
your warranty.
 DO NOT cover the side slot of the vacuum during operation. The
impeller /motor may be damaged as a result.
 DO NOT leave the pool vacuum in the water when it is not in use.
1) B ring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/OFF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool. Otherwise it may bend the pole connector and damage it during the
process. Make sure to assemble the handle as well. Hold both the handle and telescopic
pole simultaneously to place the pool vacuum into water.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool. Otherwise, the pole connector may be bent and damage the pool vacuum
in the process. Make sure to hold the handle as well when lifting the pool vacuum out of
the water.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING! Using the pool vacuum without a filter screen in place will
VOID your warranty.
16