Intended Use - Hilti BX 3-BT Manual De Instrucciones Original

Thermal safety rules
▶ Do not exceed the recommended maximum fastener driving rate (see the section headed "Technical
data").
▶ If the tool has overheated, allow it to cool down.
▶ Do not dismantle the tool while it is hot. Allow the tool to cool down.
2.4 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product
3.2

Intended use

The product is a hand-held, cordless fastening tool. It is designed for driving threaded studs (X-BT) into
steel. Use only approved threaded studs in combination with the corresponding fastener guide.
The fastening tool, battery and threaded studs together form a technical entity. Use the Hilti threaded studs
specially manufactured for the tool and the batteries and chargers recommended by Hilti. The fastening and
application recommendations made by Hilti apply only when these conditions are observed.
▶ The fastening tool is for hand-held use only.
▶ Misuse of the fastening tool must be ruled out. Misuse includes triggering without an X­BT fastener
inserted in the fastener guide.
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C 4/36 series to charge these batteries.
3.3 Bluetooth
The product has a Bluetooth interface. Wireless communication via Bluetooth is possible as soon as the
battery has been fitted and the fastening tool switched on at the on/off button.
Data transfer continues for three hours after the tool has switched to standby mode or after the tool has
been switched off at the on/off button.
*2209576*
Printed: 20.09.2019 | Doc-Nr: PUB / 5514238 / 000 / 00
1
@
;
=
%
&
(
)
+
§
/
:
2209576
Fastener guide (X­FG B3 series)
Fastener driving depth adjuster
Fastener guide locking catch
Air vents
Belt hook
Trigger
Grip
Release buttons (also used to activate the
charge status indicator)
Li­ion battery
Status indicator
On/off button
English 17