Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1)
Use a dry rag to wipe away any fuel which has been spilt onto the unit.
2)
Extract fuel from the tank and run the engine until it stops naturally.
3)
Remove the sparking plug and put in 1-2cc of 2- stroke oil in the engine. Pull the starter
rope 2-3 times, set the plug back, and stop it at the contraction position.
4)
Apply anti-rust oil to the metal parts such as the throttle wire, etc., put the cover on the
blade, and keep it indoors to avoid exposing it to dampness
10. STORAGE
So that the hedge trimmer will work again after a long period of inactivity, you should
observe the following points:
Empty the petrol tank. To do this, start the engine and let it run until it reaches a standstill.
Dispose of the remaining petrol in an environmentally friendly way.
Let the engine cool and take out the sparking plug.
Pour a small spoonful of 2-stroke mixture into the sparking plug opening and slowly pull
the starter cord right through to the end several times. This gets rid of small deposits of
rust and lubricates the piston and cylinder.
Check the sparking plug and replace it if too much of the firing tip has been burnt off.
Keep the blade in a dry place – out of the reach of fire.
23
Publicidad
Tabla de contenido
