Assembly Instructions - Felker MIX MASTER Instrucciones De Operación Y Lista De Piezas

Assembly Instructions

(Numbered call-outs reference figure 1 see pg. 14, unless otherwise instructed)
Place the main frame (item 18) on a level surface as
illustrated in this diagram. Insert and secure the draw bar
(item 20) into the main frame with the M10 x 65 capscrew
(item 19) and M10 nut (item 22), using the open wrench
provided in the assembly kit.
Slide the wheels (item 8) onto the main frame bar (item
18) and anchor them in place with the cotter pins (item
13) which are included in the assembly kit provided with
each Mix Master mixer.
Fit the gear-box frame and motor assembly (item 7) into
the swivel bracket (item 15 with the pivot axle (item 17),
slide the split pin (item 16) through the pivot axle hole.
Slide the swivel bracket (item 15) onto the main frame
upright (item 18). The gear-box and motor assembly
(item 7) is mounted into this swivel bracket.
Mount the mixing drum (item 4) onto the gear-box shaft
(item 42, figure 2 pg. 11) by aligning the guide notch with
the locating pin on the gear shaft. Secure the mixing
drum to the gear-box shaft with the T-bolt (item 5) and
washer (item 6) provided with the assembly kit.
Secure the mixing paddle (item 2) to the inside of the
mixing drum (item 4) with the M12 x 25 screws (item 1)
and M12 nuts (item 3) provided with the assembly kit.
Assemble the screw heads on the outside of the mixing
drum. Finally, insert the tilting handle (item 10) in the
gear-box frame and lock using the cotter pin (item 13)
provided in the assembly kit.
7