Primo HSM 70.2 700 Manual De Usuario página 9

5 Troubleshooting
Paper jam
You have fed in too much paper.
NOTICE! Do not press rocker switch alter-
nately forwards/backwards ( - ).
Cutting unit could be damaged.
• Press rocker switch .
 Pa per is pus hed out.

• Se pa ra te pa per stack.
• Press rocker switch .

• Feed in pa per successively.
Shredded material container full
NOTICE! Empty the cut material container,
immediately because if it is too full,
malfunctions can occur in the cutting
system.
• Press automatic start stop control for
2 sec.
• Switch equipment off. To do this tap
rocker switch .

• Move cutting head away.
• Empty cut material container.
• Remove cutting head.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 15 to
20 minutes before using it again.
0904
HSM 70.2
Primo 700
6 Cleaning
Switch off the shredder and pull out the mains
plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
9