Carton Contents; Handle Assembly - sunjoe MJ-HVR12E Manual Del Operador

Unpacking

Carton Contents

• Electric hover blade grass cutter
• Upper handle frame
• Lower handle frame
• Handle frame knobs and bolts (2)
• Cable clips (3)
• Extension cord restraint hook
• Replacement blades (3 pcs)
• Manual and registration card
1. Carefully remove the hover blade grass cutter and check
to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage
or damage occurred during shipping. If you find damaged
or missing parts, DO NOT return the unit to the store.
Please call the Snow Joe
department at 1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
hover blade grass cutter. The packaging is made of
recyclable materials. Properly dispose of these materials
in accordance with local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils, or small
parts. These items can be swallowed and pose a suffocation
risk!
Assembly
m
WARNING!
Do not connect to the power supply
until assembly is complete. Failure to comply could result in
accidental starting and serious personal injury.
m
WARNING!
Never operate the grass cutter without the
proper devices in place. Never operate the grass cutter with
damaged safety devices. Failure to heed these warnings can
result in serious injury.
+ Sun Joe customer service
® ®

Handle Assembly

1. Remove the handle rotating knobs that are preassembled
on the sides of the unit (Fig. 1).
Fig. 1
Handle rotating knobs
2. Insert the ends of the lower handle frame into the slots on
both sides of the deck. Align the holes (Fig. 2).
NOTE: There's two holes on the side pieces. Make sure
to use the bigger one on the bottom for handle frame
assembly.
Fig. 2
Slot
3. To secure the lower handle frame, insert the handle
rotating knob into the holes, rotate clockwise to tighten
(Fig. 3). Repeat on the other side.
7
Lower handle frame
Align
the
three
holes