Midland ENERJUMP Manual De Instrucciones página 17

All manuals and user guides at all-guides.com
CHARGING ENERJUMP
1. Plug the wall adaptor into the universal socket.
2. Connect the 14V-1A input port of of Enerjump to the other end of the wall
charger.
or
3. Plug the car adaptor into the socket of the cigarette lighter.
4. Connect the 14V-1A input port of Enerjump to the other end of the car adap-
tor.
STARTING A VEHICLE
1. Make sure that Enerjump is properly charged (the number of the indicator lights
must be not less than 3).
2. Turn off all the accessories on the vehicle.
3. Connect the red battery clamp of the jumper cable to the vehicle's positive (+)
battery terminal and connect the black battery clamp to the vehicle's negati-
ve (-) battery terminal. Pay attention to the polarity! A reverse polarity con-
nection (positive to negative) may cause damage to Enerjump and/or create a
sparking/explosion hazard.
4. Plug the cord of the jumper cable into the jump start socket.
5. Press the BOOST key on the clamps' circuit; then you will fi nd on the following
options:
- Green led on: the connection is correct and the circuit is working. You can
12 - ENERJUMP